Table of Contents
Advertisement
Testing a Handset
PN: 1725-36038-001_N.docx
It may be necessary to charge the handset before performing this
test. If so, place the handset into the charger for a minimum of two
hours before using it.
Verify proper registration and operation of each handset by
performing the following tests on each handset in an active wireless
area.
1. Power on the handset by pressing the
messages will be displayed as the handset acquires the system.
The handset should display the user extension.
2. Place a call and listen to the audio quality. End the call by
pressing the
END
3. Place a call to the handset and verify ring, answer, clear
transmit, and clear receive audio.
4. Use the softkeys to verify all softkey programmed features on
the handset.
5. Press the
key. Any line indicators should turn off and the
END
extension number display will return.
If any of these steps fails to operate as described, refer to
Troubleshooting
for corrective action.
END
key.
6
key. A series of
Chapter 11:
81
Advertisement
Table of Contents
