Diagnostics - Polycom SpectraLink 1725-36038-001 Administration Manual

Diagnostics

PN: 1725-36038-001_N.docx
If the highlighted power transmit level is legal on all of the
subbands for the set mode, an
softkey to apply that level to all subbands and return to the
All
subband menu where all subbands will now be selected.
overrides any previously set power transmit levels.
Without subbands: When the 802.11 mode has no subbands, the
Transmit Power
mode. Only those power levels which apply to the domain
and 802.11 mode are listed. Navigate to the desired level and
press . This sets the transmit power level and exits the
NavOK
Regulatory Domain
display.
Note that the power setting selected specifies the maximum
for that band/subband. When Transmit Power Control (TPC)
is enabled in the infrastructure, the AP may instruct the
handset to use a lower value to match its own transmit power.
Run Site Survey
The mode is activated by selecting this option. The site
Site Survey
survey starts running immediately upon selecting this option. See the
Diagnostic Tools section for more information about site survey.
Diagnostics Mode
Diagnostics can be enabled or disabled. See Chapter 8 Diagnostic
Tools, section Diagnostics Enabled
mode options.
Diagnostics
Syslog Mode
See Chapter 8 Diagnostic Tools, section Syslog Mode for a detailed
explanation of the
Syslog
Error Handling Mode
The mode determines how the handset will behave
Error Handling
when an error occurs. The
to stop operating if an error message is received. Unless the error is a
fatal one, normal operation may be resumed by power-cycling the
handset. The
Restart on Error
Configure Each SpectraLink Wireless Telephone
softkey will appear. Press the
All
list opens when
NavOK
menus. The
Network Setup
for a detailed explanation of the
mode options.
option will cause the handset
Halt on Error
option will cause the handset to make
All
is pressed to set the
menu will again
73