Polycom SpectraLink 1725-36038-001 Administration Manual page 51

PN: 1725-36038-001_N.docx
See the next chapter for complete information on configuring the
handsets as described in steps 3 through 5 below.
3. If using the settings.txt file for remote configuration, set the
parameters in the file. See previous chapter, Chapter 4: System
Configuration, and Appendix B for detailed information.
Ensure the slnk_cfg.cfg GET statement points to the correct
filename if it is different than settings.txt.
4. Depending on which configuration method you have chosen,
set parameters on each handset.
a Version 2: HAT plus Remote: set minimum parameters for
associating to the WLAN:
− QoS method: Configure the QoS handset mode to match the
AP and site QoS plan. Follow the VIEW Configuration Guide
for the appropriate make/model of WLAN.
− SSID
Security method: Configure handset security settings to match
−
AP configuration and RADIUS server settings. If WPA2-
Enterprise security is used, credentials will need to be installed
onto the handset. For EAP-FAST, the PAC file needs to be
provisioned and for PEAP the handset will need to be enrolled
with a certificate (initial configuration requires use of the
HAT). See the WPA2 Enterprise PEAP Certificate Enrollment
and EAP-FAST Manual PAC Provisioning
guide for details.
− Any security sub-options required for initial access to network
Regulatory domain
−
Radio band
−
DHCP or static IP addresses
−
b Version 2: Manual plus Remote: set minimum parameters
for associating to the WLAN as above using the Admin
menus
c HAT: set all parameters for associating to the WLAN as
above.
See the next chapter, for detailed configuration instructions.
5. Power cycle the handset.
6. The SIP code will now download to the handset. The status bar
will increment fully across the display for each function that is
Download and Install Handset Software
section in this
51