Polycom SpectraLink 1725-36038-001 Administration Manual page 85

PN: 1725-36038-001_N.docx
− -45dBm when 54Mbps is set Required and other
802.11g rates Required, Enabled or Disable
802.11 Minimum Available
Radio Standard Signal Strength (RSSI)
-60 dBm
802.11g
-45 dBm
− The critical factor is the highest data rate set Required
or Mandatory. Other 802.11g data rates can be set
Required, Enabled or Disabled. The highest data rate
set Required or Mandatory determines the RF power
available to the wireless telephone for proper
operation.
-45dBm when 54Mbps is set Required and other 802.11g
rates Required, Enabled or Disable
The handset configured for 802.11g requires:
− -60dBm when all 802.11a data are available (with only 6Mbps
set Required)
− -45dBm when 54bps is set Required and other data rates
Required, Enabled or Disabled
802.11 Minimum Available
Radio Standard Signal Strength (RSSI)
-60 dBm
802.11a
-45 dBm
The critical factor is the highest data rate set Required or
−
Mandatory. Other 802.11a data rates can be set enabled or
disabled. The highest data rate set Required or Mandatory
determines the RF power available to the wireless telephone
for proper operation.
3. Finally, use the single AP (
to ensure it is configured for the proper data rates, beacon
interval, 802.11 options enabled, QoS method, and security
method.
Make any necessary adjustments to AP locations and configurations
and repeat steps 1 through 3 until the site survey shows adequate
coverage and correct configuration at every location.
Certifying the Handsets
Maximum
"Mandatory" Data
Rate
6 Mb/s
54 Mb/s
Maximum
"Mandatory" Data
Rate
6 Mb/s
54 Mb/s
/ ) display to check each AP,
MyID Detl
85