Polycom SpectraLink 1725-36038-001 Administration Manual page 123

Polycom wireless telephone administration guide
Table of Contents

Advertisement

Message
Description
Cert Expired
When WPA2-Enterprise with PEAP
authentication is selected, the handset
failed to connect due to an expired
certificate on the handset or
authentication server.
Cert Invalid
When WPA2-Enterprise with PEAP
authentication is selected, the Wireless
Telephone failed to connect to the
network because the certificate start
date is in the future.
Charging ...
The handset is charging in the desktop
charger.
Charge Complete
The handset is now fully charged.
Charger Error
The handset has detected a problem
with the charging circuitry.
Checking Code
Handset is contacting the provisioning
server to determine if it has a newer
version of software that should be
downloaded.
Checking DHCP
The handset is retrieving DHCP
IP
information from the DHCP server.
CRC Code Error
The software which has been
provisioning downloaded has a bad
redundancy code check.
Code Mismatch!
The software loaded into the handset
is incorrect for this model handset.
PN: 1725-36038-001_N.docx
Action
Verify that the NTP server is properly
configured with the correct time.
Verify that the certificates loaded on the
handset and authentication server have
valid start/end dates by looking at "valid
to" field from "validity" data in
certificates.
If any of the certificates have expired
replace them with new certificates.
Verify that the NTP server is properly
configured with the correct time.
Verify that the certificates loaded on the
handset and authentication server have
valid start/end dates by looking at "valid
from" field from "validity" data in
certificates.
If any of the certificates have expired
replace them with new certificates.
No action needed.
No action needed.
Allow the charger and battery to cool. If
the problem persists, try a new or
confirmed battery. If the problem still
persists, contact technical support and
report the error.
None, this message should only last for
approximately one second. If message
remains displayed, power off and
contact customer support for a
replacement phone.
None. This is informational only.
Try the download again; it is possible
the software was corrupted during
download. If the error repeats, check
that the download image on the TFTP
server is not corrupted.
Verify the License Management value is
correct. Replace the software image on
the TFTP server with software that is
correct for the handset model.
Troubleshooting
123

Advertisement

Table of Contents
loading

This manual is also suitable for:

Spectralink 8020Spectralink 8030

Table of Contents