Table of Contents
Advertisement
Configure Call Server
Configure Access Points
Configure SIP Handset Files
PN: 1725-36038-001_N.docx
See the documentation which accompanies your call server. Review
the proxy information in this document for configuration
requirements. You will also need to configure an extension and
related information for each handset to be deployed.
See the documentation which accompanies your access point.
Polycom VIEW certified access points are listed in the
Certified Products
Guide. Configuration Guides for each certified
product can be found on the Polycom website. See the
Documents
section at the beginning of this document for link
information.
During normal handset setup in the SIP environment, two files are
downloaded from the provisioning server during startup. These files
are obtained from either the default HTTP directory (specified in the
HTTPDIR parameter) or the root directory of the TFTP server.
Version 1 Configuration Mode
The first file, the sip_allusers.cfg file, contains generic system
information and is downloaded by every handset during the power-
up sequence. A second file, the sip_xxxx.cfg file, which is unique for
each handset, is then downloaded. It contains specific information for
each handset such as username, password, and line appearances. Both
of these files must be written specifically for the facility where the
handsets will operate.
If the handset cannot find at least one of these files, then it will not
boot to the application, but will display a warning message.
Version 2 Configuration Mode
The first file, the settings.txt file, contains generic system information
and is downloaded by every handset during the power-up sequence.
A second file, the sipxxxx.txt file, which is unique for each handset, is
then downloaded. It contains specific information for each handset
such as username, password, and line appearances. Both of these files
System Configuration
Polycom VIEW
Related
31
Advertisement
Table of Contents
