Replacing A 2.5-Inch Backplane - Fujitsu PRIMERGY TX1320 M5 Upgrade And Maintenance Manual

Removing the defective 2.5-inch HDD/SSD module
▶ Remove the HDD/SSD module, see
modules" on page
▶ If applicable, remove the HDD/SSD from the installation frame, see
"Handling HDDs or SSDs without installation frame" on page
Installing the new 2.5-inch HDD module
▶ If applicable, install the HDD/SSD in the installation frame, see
HDDs or SSDs without installation frame" on page
▶ Install the HDD/SSD module, see
on page 152.
Concluding steps
▶ If the HDD/SSD is configured using a RAID controller with a RAID level
higher than "0", the rebuild will start automatically, see
array rebuild" on page
▶
"Reassembling" on page
7.5.7

Replacing a 2.5-inch backplane

Field Replaceable Unit
(FRU)
Tools:
Phillips PH2 / (+) No. 2 screw driver
Preliminary steps
If a PCIe backplane should be installed, remove the HDD backplane
from the first place and install it as the second backplane. The PCIe
backplane is always installed as the first backplane.
The HDD backplane is mounted on the HDD cage. It is not necessary to
remove the HDD cage before installing or removing the HDD backplane.
TX1320 M5
Hard disk drive (HDD) / solid state drive (SSD)
154.
"Installing 2.5-inch HDD/SSD modules"
92.
54.
Upgrade and Maintenance Manual
"Removing 2.5-inch HDD/SSD
135.
Hardware: 10 minutes
135.
"Handling
"Performing a RAID
159