Flash Backup Unit (Fbu); Position Of The Fbu - Fujitsu PRIMERGY TX1320 M5 Upgrade And Maintenance Manual

Concluding steps
▶
"Reassembling" on page
▶ If applicable, connect external cables to the expansion card.
▶
"Connecting the power cord" on page
▶
"Switching on the server" on page
▶
"Enabling replaced components in the BIOS" on page
▶ Inform the customer about changed WWN and MAC addresses, see
"Looking for MAC/WWN/GUID and SAS addresses" on page
▶ After replacing a network controller in a server running Linux OS, see
"Updating the NIC configuration file in a Linux and VMware environment" on
page 90.
▶
"Updating expansion card firmware" on page
▶
"Resuming BitLocker functionality" on page
▶ If applicable, reconfigure your network settings in the operation system
according to the original configuration of the replaced controller (expansion
card or onboard).
Configuration of network settings should be performed by the
customer. For more information, see
recovery" on page
▶ If applicable, restore LAN teaming configurations, see
upgrading LAN controllers" on page
9.6

Flash backup unit (FBU)

9.6.1

Position of the FBU

The FBU backs up the memory contents of the RAID controller in the event of
a power failure. One FBU can be installed in the system.
Depending on the RAID controller, different FBUs are available. In
configurations with PRAID EP5x0i/EP6x0i, an FBU345 is required.
TX1320 M5
Expansion cards and backup units
54.
57.
60.
206.
98.
Upgrade and Maintenance Manual
87.
79.
91.
"Note on network settings
"After replacing or
93.
207