Fujitsu PRIMERGY TX1320 M5 Upgrade And Maintenance Manual page 165

Figure 86: Example: Connecting cables to an HDD backplane
▶ Connect the cables to the HDD backplane:
1 Power cable to the connector "PWR1"
2 Signal cable to the connector "P1"
3 OOB cable to the connector "SMBSYS"
▶ If applicable, place the free connectors in an empty bay.
▶ Run the cables under the HDD cage.
For the cable plan, see
Concluding steps
▶ Insert all HDD modules, see
page 152.
Ensure that you install the HDD/SSD module in the bay it was located
before the HDD backplane replacement.
▶ Install the HDD fan modules 2.5-inch HDD variant, see
fan module (2.5-inch HDD variant)" on page
TX1320 M5
Hard disk drive (HDD) / solid state drive (SSD)
"Appendix B" on page
"Installing 2.5-inch HDD/SSD modules" on
Upgrade and Maintenance Manual
375.
"Installing the HDD
68.
165