Fujitsu PRIMERGY TX1320 M5 Upgrade And Maintenance Manual page 149

Preliminary steps
▶
"Locating the defective server" on page
▶
"Locating the defective component" on page
▶
"Shutting down the server" on page
▶
"Getting access to the component" on page
Removing the defective 3.5-inch non hot-plug HDD
▶ Remove the non hot-plug HDD, see
HDDs" on page
Installing the new 3.5-inch non hot-plug HDD
▶ Install the non hot-plug HDD, see
on page 137.
Concluding steps
▶
"Reassembling" on page
▶
"Connecting the power cord" on page
▶
"Switching on the server" on page
▶ If the HDD/SSD is configured using a RAID controller with a RAID level
higher than "0", the rebuild will start automatically, see
array rebuild" on page
TX1320 M5
Hard disk drive (HDD) / solid state drive (SSD)
143.
54.
92.
Upgrade and Maintenance Manual
43.
44.
45.
48.
"Removing 3.5-inch non hot-plug
"Installing 3.5-inch non hot-plug HDDs"
57.
60.
"Performing a RAID
149