Fujitsu PRIMERGY TX1320 M5 Upgrade And Maintenance Manual page 160

Hard disk drive (HDD) / solid state drive (SSD)
▶
"Locating the defective server" on page
▶
"Shutting down the server" on page
▶
"Disconnecting the power cord" on page
▶
"Getting access to the component" on page
▶ Remove the HDD fan module (2.5-inch HDD variant), see
HDD fan module (2.5-inch HDD variant)" on page
▶ Release all HDD modules and pull them out a few centimeters, see
"Removing 2.5-inch HDD/SSD modules" on page
CAUTION
The HDD modules need not to be removed.
▶
If you want to remove them nevertheless, check if all HDD
modules are uniquely identified so that you can reinsert them
into their original bays.
▶ Release all dummy modules and pull them out a few centimeters, see
"Removing a 2.5-inch HDD/SSD dummy module" on page
Removing a 2.5-inch HDD/PCIe backplane
The following description is valid for:
– An HDD backplane
– A PCIe backplane
Configurations with up to four 2.5-inch HDDs/SSDs, there is one HDD
backplane. Configurations with up to eight 2.5-inch HDDs/SSDs, there
are either two HDD backplanes or one PCIe backplane (backplane 1)
and one HDD backplane (backplane 2).
▶ If there are two backplanes, locate the defective backplane.
▶ If applicable, disconnect all cables from the backplane(s).
160
45.
Upgrade and Maintenance Manual
43.
46.
48.
67.
154.
"Removing the
152.
TX1320 M5