Fujitsu PRIMERGY TX1320 M5 Upgrade And Maintenance Manual page 336

System board and components
Tools:
a pair of side-cutting pliers
Preliminary steps
▶
"Locating the defective server" on page
▶
"Shutting down the server" on page
▶
"Disconnecting the power cord" on page
▶
"Getting access to the component" on page
Replacing the microSD card
▶ Remove the Dual microSD 64GB Enterprise, see
microSD 64GB Enterprise" on page
▶ Remove the defective microSD card from the Dual microSD 64GB
Enterprise.
Proceed as described in the following:
▶ To eject the defective microSD card, gently push it in and then let go, see
Figure 225.
▶ Pull the microSD card straight out of its slot.
CAUTION
(not valid for Europe, Middle East, India and Africa)
The microSD card contains customer information.
▶
After removing the microSD card, hand the card over to the
customer.
▶
If the customer requests disposal of the defective microSD
card, proceed as follows: Using a pair of side-cutting pliers,
cut the microSD card in half.
▶ Install the new microSD card on the Dual microSD 64GB Enterprise.
Proceed as described in the following:
▶ With the label facing up, insert the microSD card into the microSD slot on
the controller until it locks in place (see
336
45.
332.
Upgrade and Maintenance Manual
43.
46.
48.
"Removing the Dual
Figure 226).
TX1320 M5