▶ Align the notch on the bottom of the module with the crossbar in the slot.
▶ Press down on the memory module until the securing clips snap into the
cutouts at each end of the module.
Figure 132: Correct position of securing clips
To improve the contact of the memory module perform the following
steps:
● Eject the memory module again by pressing out the securing clips at
each end of the memory slot.
● Press down on the memory module until the securing clips snap into
the cutouts at each end of the module.
● Check if all securing clips are in the correct position, see
position of securing clips" on page
Concluding steps
▶
"Reassembling" on page
▶
"Connecting the power cord" on page
▶
"Switching on the server" on page
▶
"Resuming BitLocker functionality" on page
TX1320 M5
54.
57.
60.
Upgrade and Maintenance Manual
225.
91.
Main memory
"Correct
225