Fujitsu PRIMERGY TX1320 M5 Upgrade And Maintenance Manual page 206

Expansion cards and backup units
Tools:
– Phillips PH2 / (+) No. 2 screw driver (only for replacing the slot
bracket)
Note on network settings recovery
When replacing network controllers or the system board, network
configuration settings in the OS will be lost and replaced by default
values. This applies to all static IP address and LAN teaming
configurations.
Ensure to note down your current network settings before replacing a
network controller or the system board.
Preliminary steps
▶
"Locating the defective server" on page
▶
"Suspending BitLocker functionality" on page
▶ If applicable, ensure to note down your current network settings.
▶
"Shutting down the server" on page
▶
"Disconnecting the power cord" on page
▶ If applicable, disconnect external cables from the expansion card.
▶
"Getting access to the component" on page
▶
"Locating the defective component" on page
Removing an expansion card
▶ Remove the expansion card, see
▶ If the slot bracket on the defective expansion card is to be reused, remove it
from the expansion card, see
Installing an expansion card
▶ If applicable, install the slot bracket, see
page 204.
▶ Install the expansion card, see
206
45.
"Removing expansion cards" on page
"Removing a slot bracket" on page
"Installing expansion cards" on page
Upgrade and Maintenance Manual
43.
71.
46.
48.
44.
"Installing the slot cover" on
203.
186.
195.
TX1320 M5