Checking On Delivery; Installation; Installing Servomotors - YASKAWA SGM Series User Manual

Installation and Wiring

8.2.1 Installing Servomotors

8.1 Checking on Delivery

8.2 Installation

8.2.1 Installing Servomotors
!
8
When Σ-Series products are delivered, check the following items:
Check Items
Check if the delivered products are
the ones you ordered.
Check for damage.
Check if the motor shaft rotates
smoothly.
Check loose screws.
If any of the above items are faulty or incorrect, contact the dealer from which you purchased the
products or your nearest sales representative. Be sure to confirm that there are no loose screws, break-
age in lead wires, or damage in insulation.
The Servomotor can be installed either horizontally or vertically. If the Servomotor is installed
incorrectly or in an inappropriate location, the service life will be shortened or unexpected prob-
lems will occur. To prevent this, always observe the installation instructions provided below.
Do not connect the Servomotor directly to a commercial power supply. Doing so
CAUTION
will damage the motor.
The Servomotor will not operate unless connected to the proper SERVOPACK.
J Before Installation
Anticorrosive paint is coated on the edge of the motor shaft to prevent corrosion during storage.
Before installation, clean off the anticorrosive paint thoroughly using a cloth moistened with
thinner. Avoid getting thinner on other parts of the Servomotor when cleaning the shaft.
J Installation Site
The Servomotors are designed for indoor use. Install Servomotor in an environment which meets
the following conditions:
Check the model numbers marked on the nameplates of
Servomotor and SERVOPACK.
Check the overall appearance, and check for damage or
scratches resulting from transportation.
If the motor shaft can be smoothly turned by hand, it is
normal. If the motor has a brake, however, it cannot be
turned manually.
Check for looseness by using a screwdriver as necessary.
Anticorrosive paint is
coated here.
8 -2
Remarks