Bosch rexroth Nexo Manual page 94

Bosch Rexroth AG | Tightening Technology
94/279
MID 0019 revision 002
Table 7–16:
Parameter
This revision includes the information from revision 001 and the following additional information:
NOK counter value
Data length revision 002
MID 0020 Deactivating the selected OK/NOK counter
Sent by: superordinate computer
This message allows to deactivate the OK/NOK counter value of the Automatic operating mode specified in the
command ("Tightening program number" parameter)
Note: If the Keep programmed counters option is enabled only the current actual values of the
OK/NOK counter values are reset.
Revision: 001
Data field: tightening program number, three ASCII characters (000–999), 3 bytes
Possible responses
Command accepted
Command error
MID 0021 Deactivating all OK/NOK counters
Sent by: superordinate computer
This message enables the deactivation of all OK/NOK counter values of the operating mode Automatic.
Note: All counters of all programs are switched off. The counter values have to be re-enabled via MID 0019.
Revision: 001
Data field: is empty, 0 bytes
Possible responses
Command accepted
7.5.3.5 Job messages
MID 0030 OK counter upload request
Sent by: superordinate computer
All configured OK counters (0 to 255) in the tightening system are transferred as a result of this request.
Note: -
Revision: 001
Data field: is empty, 0 bytes
Possible response
Job numbers upload response
MID 0019 revision 002
Comments
The value consists of two ASCII characters.
ID
Value range
Presetting
Example:
NOK counter value
Value
MID
0005
0004
MID
0005
MID
0031
Nexo cordless Wi-Fi nutrunner | 3 608 870 A47/2019-10
-
00 – 99
-
5
05
Error no. Comment
–
01 Invalid data
04 Tightening program not active
Error no. Comment
–
Error no. Comment
–
3 608 870 A47
Bytes
2
7