Bosch rexroth Nexo Manual page 203

3 608 870 A47
9.7.4.1 Start step
Table 9–38:
Element
Name
Category
Graph characteristics
Table 9–39:
Element
Graph resolution
Measuring points
Torque unit
Resolution and number of measuring points must be properly adjusted for each tightening process.
Nexo cordless Wi-Fi nutrunner | 3 608 870 A47/2019-10
Double clicking the start step or the respective icon of a tightening program will open a
dialog where the associated parameters can be entered.
Start step dialog
Description
Start step name
Admissible characters are ASCII characters, numbers, spaces, hyphens,
dashes and underscore.
Is used to select the category for determining the quality code. The quality
code describes whether a tightening job was evaluated as OK or NOK. With
an NOK evaluation, the cause will also be described. In NOK cases, the
category is used as a detailed distinction, so that a different quality code can
be output in different tightening steps for the same NOK cause (e.g. M < M–).
Possible categories include e. g.:
– Start
– Tightening
– Pre-tightening
– Final tightening
– Loosen
– Rework
Start step dialog - graph properties panel
Description
Is used to select the graph resolution in angular degrees. The smallest value
(0.25°) results in the highest resolution and the highest value (50°) in the
lowest resolution.
Default setting: 1°
The resolution selected here applies to the entire tightening program.
However, each tightening step can be set individually, if necessary, e.g. to
display less interesting graph sections with a lower resolution.
Is used to select the measuring points for creating the graph.
Value range: 100 - 2000
Selects the desired unit to be used by the NEXO-OS operating system to
display and calculate the torque for this tightening program.
The pre-set value is the value selected in menu Settings during configuration
of the nutrunner.
Tightening Technology | Bosch Rexroth AG 203/279