Nexo-Os Operating System; Commissioning - Bosch rexroth Nexo Manual

Bosch Rexroth AG | Tightening Technology
172/279
8.2

NEXO-OS operating system

8.2.1

Commissioning

The following web browsers are supported for the NEXO-OS operating system:
•
•
•
•
Opening the NEXO-OS operating system
1.
2.
3.
4.
5.
6.
7.
8.
Configuring the NEXO-OS operating system
•
•
•
•
Access via access point
The browser-based NEXO-OS operating system allows configuring the Nexo cordless Wi-Fi nutrunner
on any computer desired. An access point is required for wireless transmission of data via WLAN be-
tween the Nexo cordless Wi-Fi nutrunner and an operating computer. Existing access points of the infra-
structure (WLAN standard IEE 802.11 a, b, g and h) can be used.
The WLAN interface is deactivated by default. After it is activated, the connection to the
access point is established.
For information on how to install the access point, refer to the operating instructions of the access point.
For detailed information on data communication, refer to chapter
For detailed information on control signal exchange, refer to chapter
Internet Explorer version 7.0 and higher
Mozilla Firefox version 3.6 and higher
Apple Safari version 6.1.2 and higher
Google Chrome
Complete all mounting steps.
Insert the battery and press the red button on the battery to activate it.
Briefly actuate the start switch on the hand-held nutrunner.
Slide the interface cover forward.
Insert the MicroUSB to Ethernet adapter NX-A into the interfaces provided.
Open the network connections on your PC and add a new LAN connection:
– Click LAN Connections - Properties.
– Activate Internet Protocol Version 4 (TCP/IPv4).
– Click Properties and enter address 192.168.1. plus any one- to three-digit number (no 10).
Note: Use one of the addresses 192.168.1.1 ... 192.168.1.9 Otherwise, routing problems may oc-
cur if WLAN is used in the same subnet.
– Confirm your settings with OK.
Now open your web browser and enter the default IP address of the Nexo cordless Wi-Fi nutrunner:
192.168.1.10
Then enter the default user data on the login page.
– User: Bosch
– Password: Robert
Configuring the WLAN (see page 240)
Defining the tightening programs
Defining the PLC assignment table
Setting the nutrunner time (see page 208)
(see page 214)
(see page 236)
Data services from page
Nexo cordless Wi-Fi nutrunner | 3 608 870 A47/2019-10
3 608 870 A47
69.
Control signals from page 57.