Bosch rexroth Nexo Manual page 85

3 608 870 A47
7.5.3.2 Message specification
MID 0001 Communication start
Sent by: superordinate computer
Activates the command connection. Until this is done, the tightening controller will not respond to any other
command.
Note: This message must be sent to connect the client to the tightening system.
Revision: see
Data field: is empty, 0 bytes
Possible responses
Acknowledgement of communication
start
Command error
MID 0002 Acknowledgement of communication start
Sent by: Tightening controller
Once communication has been established, the tightening controller sends a communication start acknowledgement
as a response. This message contains basic information on the tightening controller that has accepted the connection
(cell ID, channel ID, controller name, ...).
Note: -
Revision:
Data field: Data 37 bytes (revision 001), 42 bytes (revision 002), 105 bytes (revision 003)
Possible response: none
MID 0002 revision 001
Table 7–7:
Parameter
Cell ID
Channel ID
Controller name
Data length revision 001
Nexo cordless Wi-Fi nutrunner | 3 608 870 A47/2019-10
MID 0002
MID
0002
0004
001, 002, 003
MID 0002 revision 001
Comments
This is where the 7th level of the location name is returned.
The value consists of four ASCII characters.
ID
Value range
Presetting
Example:
Cell ID
Value
The channel ID is the channel number value assigned in the channel
configuration. Value range 1–99
ID
Value range
Presetting
Example:
Channel number
Value
The controller name is the channel name assigned in the configuration of
the nutrunner. The value consists of 25 ASCII characters.
ID
Value range
Presetting
Example:
Controller name
Value
Tightening Technology | Bosch Rexroth AG
Error no. Comment
96 Client already connected
01
0000 – 9999
0001
3
0003
02
01 – 20
01
04
04
03
0x20 – 0x7F
***, means no controller name
Tightening channel
Tightening channel
85/279
Bytes
2
4
2
2
2
25
37