Tool Display - Bosch rexroth Nexo Manual

3 608 870 A47
9.8.2.5 My account
Settings  User accounts  My account
This menu item displays the user data of the logged-in user.
Table 9–52:
Element
Change password
9.8.3

Tool display

Settings  Nutrunner display
Use this menu item to define the settings for the display on the portable Nexo cordless Wi-Fi nutrunner.
Also see section
General panel
Under General, the first screen of the tool display can be defined.
Table 9–53:
Element
First view
Design
Language
Options panel
Table 9–54:
Element
Allow acknowledgement of system
errors
Enforce acknowledgement of NOK
results
Show data connection status
Nexo cordless Wi-Fi nutrunner | 3 608 870 A47/2019-10
My account tab
Description
Click Change password to change your password:
1. Enter your old password, then your new password and confirm the latter.
2. Click Confirm to confirm the setting.
Tool display (page 26)
.
Tool display index card - General panel
Description
Under First screen, select the screen to be displayed first on the display of
the Nexo cordless Wi-Fi nutrunner.
Selects the display representation: Day or Night
Selects the display language
Tool display index card - Options panel
Description
Enable Allow acknowledgement of system errors to acknowledge system
errors using the nutrunner display.
As of Nexo firmware version 1200: Enable Allow acknowledgement of
NOK results to acknowledge NOK results using the nutrunner display.
Note: Activation does not become active before the first tightening process
after commissioning of the Nexo cordless Wi-Fi nutrunner.
If the NokAc PLC input signal is applied to 0.3 - 0.5 in the tool PLC module,
NOK results can also be acknowledged at the tool display (program selector
in center position). On application of the NokAc PLC input signal in the PLC
table and activation of the Enforce acknowledgement of NOK results
option, the option has priority on the nutrunner display.
Note: If with activated Enforce acknowledgement of NOK results option,
a NOK result occurs, the Rdy PLC output signal will be set to "Low". After
confirmation, the signal will change back to "High".
As of Nexo firmware version 1200: Enable the check box to display the data
connection status on the nutrunner display.
As of Nexo firmware version 1300, Display status of the data connection
is activated by default.
Tightening Technology | Bosch Rexroth AG 211/279