Bosch rexroth Nexo Manual page 143

3 608 870 A47
Table 7–43:
Parameter
Line 1
Line 2
Line 3
Line 4
Data length revision 001
MID 0127 Aborts a job
Sent by:
This command can be used to abort a running job.
Note:
Revision:
Data field:
Possible response
Command accepted
Command error
Nexo cordless Wi-Fi nutrunner | 3 608 870 A47/2019-10
MID 0111 revision 001
Comments
Fill in with empty spaces if < 25 characters.
The value consists of a maximum of 25 ASCII characters. The tool display
can represent up to 15 characters per line.
ID
Value range
Presetting
Example:
Line 1
Value
Fill in with empty spaces if < 25 characters.
The value consists of a maximum of 25 ASCII characters. The tool display
can represent up to 15 characters per line.
ID
Value range
Presetting
Example:
Line 2
Value
Fill in with empty spaces if < 25 characters.
The value consists of a maximum of 25 ASCII characters. The tool display
can represent up to 15 characters per line.
ID
Value range
Presetting
Example:
Line 3
Value
Fill in with empty spaces if < 25 characters.
The value consists of a maximum of 25 ASCII characters. The tool display
can represent up to 15 characters per line.
ID
Value range
Presetting
Example:
Line 4
Value
superordinate computer
The Job Abort PLC signal has to be applied at the input of the oprtcl module.
001 (supported by Rexroth OP)
is empty, 0 bytes
Tightening Technology | Bosch Rexroth AG 143/279
3
0x20 – 0x7F
-
Title
Title
4
0x20 – 0x7F
-
Line 2
Line 2
5
0x20 – 0x7F
-
Line 3
Line 3
6
0x20 – 0x7F
-
Line 4
Line 4
MID Error no. Comment
0005 –
0004 98 Request timeout in the control or PLC signal not
assigned in the PLC assignment table.
Bytes
2
25
2
25
2
25
2
25
117