Installing Memory; Restoring The Chassis - Fujitsu Oracle M10-1 Service Manual

16.6.2

Installing memory

This section describes the procedure for installing memory.
To install memory, see
Fit the notched section of the memory into the corresponding position of the
1.
connector of the memory slot.
Note - Reinstall the memory in their original locations by referring to the notes you made
before the start of maintenance.
Push the memory module into the slot evenly.
2.
Note - Confirm that the latch of the memory slot has returned to its original position.
16.6.3

Restoring the chassis

Install the air duct and the PSU backplane cover.
1.
For details, see
2. Install the upper cover.
For details, see
3. Close the fan cover.
For details, see
Put the chassis into the rack.
4.
For details, see
5. Connect all the cables of the external interface.
Note - Reinstall the cables in their original positions by referring to the notes that you made
before the start of maintenance.
6. Disconnect the XSCF LAN cables, and connect the serial cable.
7. Connect the power cords of the chassis requiring maintenance at their
original positions.
For details, see
Note - Reinstall the power cords in their original positions by referring to the notes that you
made before the start of maintenance.
Note - The XSCF STANDBY LED (green) on the operator panel blinks when the power cords
are connected. As the LED blinks, wait a moment for it to stay on. This indicates that XSCF
210 Fujitsu M10-1/SPARC M10-1 Service Manual ･ June 2021
"2.2 Checking the Memory Configuration
"6.1.2 Installing the air duct and PSU backplane
"6.1.3 Installing the upper
"6.1.4 Closing the fan
"6.1.5 Putting the chassis into the
"6.1.6 Installing the power
cover."
cover."
rack."
cords."
Rules."
cover."