System-Stopped Addition - Fujitsu Oracle M10-1 Service Manual

Table 7-9 Active/hot addition work procedure (for an internal disk)
Item Work procedure
1 Opening the rack door
2 Checking the operating condition of
the system and the I/O device usage
status
3 Installing an internal disk
4 Incorporating an internal disk by
using the hot plug function
5 Confirming that there is no problem
with the installed FRU
6 Closing the rack door
7.3.2

System-stopped addition

This section describes the workflows for system-stopped/hot and system-stopped/
cold FRU installation. References to detailed descriptions are written in the
workflow. See any of them as required.
System-stopped addition on the SPARC M10-1 has the following patterns:
System-stopped/hot addition (for an internal disk)
■
System-stopped/cold addition (for memory)
■
System-stopped/cold addition
■
Reference
"5.3 Checking the Operating Condition and Resource Usage
"Chapter 9 Maintaining the Internal
"6.6 Incorporating an Internal
"6.7 Checking the FRU Status after
Disks"
Disk"
Maintenance"
Chapter 7 Maintenance Flow
Status"
105