Releasing A Fru From The System With The Replacefru Command - Fujitsu Oracle M10-1 Service Manual

{0} ok printenv boot-device
boot-device = /pci@8000/pci@4/pci@0/pci@0/scsi@0/disk@p0,0
5.7 Releasing a FRU from the System with
the replacefru Command
This section describes the procedure for releasing a FRU requiring maintenance from
the system. The following FRUs can be maintained.
Power supply unit
■
Fan unit
■
Note - If the XSCF startup mode is high-speed mode, hardware cannot be replaced using the
replacefru command. Replace hardware with the input power turned off.
1. Log in to the XSCF shell.
2. Execute the replacefru command to display the maintenance menu.
XSCF> replacefru
3. Select the FRU requiring maintenance by specifying it with a numeric key.
In the following example, since the fan unit is selected, "1" is entered.
------------------------------------------------------------------------------
Maintenance/Replacement Menu
Please select a type of model which has FRU to be replaced.
1. FAN (Fan Unit)
2. PSU (Power Supply Unit)
------------------------------------------------------------------------------
Select [1,2|c:cancel] : 1
Select the FRU requiring maintenance by specifying it with a numeric key.
4.
In the following example, since FAN#6 is showing "Faulted" indicating an error,
"7" is entered.
------------------------------------------------------------------------------
Maintenance/Replacement Menu
Please select a FRU to be replaced.
No. FRU
--- ------------------- --------------
1 /FAN#0
Status
Normal
Chapter 5 Preparations Required for Maintenance 57