System-Stopped Replacement - Fujitsu Oracle M10-1 Service Manual

7.2.2

System-stopped replacement

This section describes the workflows for system-stopped/hot and system-stopped/
cold FRU replacement. References to detailed descriptions are written in the
workflow. See any of them as required.
Note - If the XSCF startup mode is high-speed mode, hardware cannot be replaced using the
replacefru command. Replace hardware by performing system-stopped/cold replacement.
System-stopped replacement on the SPARC M10-1 has the following patterns:
System-stopped/hot replacement (for a power supply unit or fan unit)
■
System-stopped/hot replacement (for an internal disk)
■
System-stopped/cold replacement
■
Chapter 7 Maintenance Flow 97