System-Stopped Maintenance (Inactive Maintenance) - Fujitsu Oracle M10-1 Service Manual

3.3 System-stopped Maintenance
(Inactive Maintenance)
The type of maintenance performed with the physical partition stopped is referred to
as system-stopped maintenance (inactive maintenance). SPARC M10-1 has the only
one physical partition. Thus, the state in which the physical partition requiring
maintenance is stopped is the same as the state in which the entire system is stopped.
Table 3-3
enabled for each FRU.
Table 3-3 Whether system-stopped maintenance (inactive maintenance) (replacement/
FRU
PCIe card
Internal disk
HDD backplane
Power supply unit
PSU backplane
Cable kit
Operation panel
Fan unit
Motherboard unit
Memory
*1 System-stopped (inactive)/hot maintenance can be performed on the PCIe cards mounted in the PCI expansion
unit. For details, see "3.3 Types of Maintenance for the PCIe Card" in the PCI Expansion Unit for Fujitsu SPARC
M12 and Fujitsu M10/SPARC M10 Service Manual.
*2 If the XSCF startup mode is high-speed mode, hardware cannot be replaced using the replacefru command.
Perform system-stopped (inactive)/cold maintenance.
shows whether system-stopped maintenance (inactive maintenance) is
addition/removal) is enabled for each FRU
System-stopped
(inactive)
/hot maintenance
- (*1)
OK
-
OK (*2)
-
-
-
OK
-
-
-: Maintenance cannot be performed.
System-stopped Reference
(inactive)
/cold maintenance
OK Chapter 8
OK Chapter 9
OK Chapter 10
OK Chapter 11
OK Chapter 12
OK Chapter 13
OK Chapter 14
OK Chapter 15
OK Chapter 16
OK Chapter 16
Chapter 3 Types of Maintenance 27