Figure 6-11 Cable management arm tab
A
6.2
Incorporating a FRU into the System
with the replacefru Command
This section describes the procedure for incorporating a Field Replaceable Unit (FRU)
into the system after maintenance. To do this, resume the replacefru command,
which is running, to incorporate the FRU into the system. The following FRUs can be
maintained.
Power supply unit
■
Fan unit
■
After performing maintenance on the FRU, return to the operation of the XSCF
1.
firmware replacefru command, and then enter "f".
Please execute the following steps:
1) Confirm the Check LED is blinking.
2) Remove FAN#6.
3) Execute either the following:
3-1) After installing the exchanged device, please select 'finish'.
3-2) If you want to suspend the maintenance without exchanging device,
please select 'cancel'.
[f:finish|c:cancel] : f
The following screen is displayed. Wait until the processing has completed.
Chapter 6 Understanding the Preparations for Restoring the System
77