Checking The Led Indications; Operation Panel Leds - Fujitsu Oracle M10-1 Service Manual

Table 2-4 Functions of the power switch (continue d)
Icon Operation
Table 2-5
Table 2-5 Functions of the mode switch
Function
Start/stop of the system by the
power switch
Inhibition of break signal
reception
2.4

Checking the LED Indications

This section describes the indications given by the system LEDs.
LEDs are mounted on the operation panel on the front of the chassis, on the rear
panel of the chassis, and on each component that can be maintained. If an error
occurs, the LED indication enables you to determine the system that requires
maintenance.
2.4.1

Operation panel LEDs

The three LEDs on the operation panel indicate the operation status of the entire
system. In addition, the LEDs enable you to check the system status by their
18 Fujitsu M10-1/SPARC M10-1 Service Manual ･ June 2021
Description
If the system stop process
is in progress in Service
mode:
If the system is stopped in
Service mode:
If the system is stopped in
Locked mode:
If the system is not
stopped in Locked mode:
describes the functions of the mode switch.
Mode switch
Locked
Only system startup is enabled.
Enabled. Using the setpparmode
command, you can specify whether to
receive break signals or inhibit their
reception for each physical partition.
Continues the system stop process.
Operation is ignored.
Even a long press does not start the system.
Starts the system.
If a wait time for the air conditioning facilities or
a warm-up time is set on the XSCF, the
processing for waiting for the power-on of the air
conditioning facilities and the completion of
warm-up is omitted.
Operation is ignored.
Service
A long press
powers off the
system.
Disabled