32 Bit Flash Memory; Usb - Fujitsu EVB JADE-­D Manual

Prepared
Manfred Ortmann
Approved
2.2.6 32 bit Flash Memory
For evaluation reasons two 256 MBit MirrorBit Flash memories ( S29GL256N10FFI02 from
Spansion, U503 and U504 ) which can be configured for the 32 bit bus of the JADE­D are
available on the EVB JADE­D Interface board.
The 32­bit mode can be configured by setting the MPX_MODE_1 [1:0] pins b'10'.
See config switch SW901 on JADE Evaluation board.
2.2.7 USB
A USB 2.0 high­speed mode host and device controller LSI with 16­bit width standard CPU bus
S1R72V18 ( U601 ) from Seiko Epson Corporation is populated. The S1R72V18 has two host
ports to function as a USB root hub. One of the ports can be used as a USB device port after
setting.
On the EVB JADE­D Interface board only the host port will be used.
The interrupt output from the USB controller is connected to the JADE­D interrupt A1 over 0
Ohm resistor R605, A2 over 0 Ohm resistor R606 and A3 over 0 Ohm resistor R607. Remove
the corresponding resistor to disconnect the connection which shall not be used !
Preliminary
Document Number
Checked Date
2009­10­05
Revision Storage
PA 4.2 Mycable01
33(45)