Fru Installation Workflow; Active Addition - Fujitsu Oracle M10-1 Service Manual

7.3

FRU Installation Workflow

This section describes the installation workflow for the following FRUs of the
SPARC M10-1:
- PCI Express card
- Memory
- Internal disk
7.3.1

Active addition

This section describes the workflow for active/hot addition of an internal disk.
References to detailed descriptions are written in the workflow. See any of them as
required.
Active addition on the SPARC M10-1 has the following patterns:
Active/hot addition (for an internal disk)
■
Active/hot addition (for an internal disk)
Active/hot addition can be performed on an internal disk. Perform the following
procedure to install the unit.
Figure 7-7 Active/hot addition flow (for an internal disk)
1. Opening the rack door
2. Checking the operating condition of the
system and the I/O device usage status
3. Installing an internal disk
4. Incorporating an internal disk by using the hot
plug function
5. Confirming that there is no problem with the
installed FRU
6. Closing the rack door
104 Fujitsu M10-1/SPARC M10-1 Service Manual ･ June 2021
Addition complete