Myride® Replacement - Toro Z MASTER 2000 Series Service Manual

Adjusting the Motion Control Handle Position (continued)
MYRIDE® Replacement
MYRIDE® Removal
2000 Series Z MASTER® Service Manual
3438-778 Rev A
g336046
4. Align the levers front to back and secure the bolts.
5. Move the levers into the park position.
6. Verify proper function of the unit.
Note: Motion control levers may be adjusted up or down for operator comfort
by utilizing the additional mounting holes on the motion control assembly.
The motion control levers should always be mounted on the inside of the
motion control assembly.
1. Park the machine on a level surface and disengage the PTO. Stop the
engine, wait for all moving parts to stop, and remove the key.
2. Lower the ROPS.
3. Remove the 2 larger nyloc nuts securing the lower shock mounts to the
ROPS. The nyloc nuts can be accessed from the rear of the machine.
4. Open the cable retainer and remove the 2 cables routed across the seat base.
Figure 54
Page 5–31 Chassis: Service and Repairs