Throttle Cable Assembly Removal (continued)
Throttle Cable Assembly Installation
2000 Series Z MASTER® Service Manual
3438-778 Rev A
g336055
5. Remove the 2 bolts and nuts securing the throttle control assembly to the
control panel assembly.
6. Loosen the clamp securing the throttle cable to the throttle plate.
g336056
7. Remove the throttle cable from the throttle plate, noting the position of the
cable in the plate.
8. Pull the throttle cable assembly through the console and out of the machine.
1. Route the throttle cable through the right console between the ROPS and
the hydraulic fluid.
Figure 39
Figure 40
Page 5–21
Chassis: Service and Repairs