Toro Z MASTER 2000 Series Service Manual page 85

Leveling the Mower Deck (continued)
Block Height and Rake Table
Deck Size
All Mower Deck
2000 Series Z MASTER® Service Manual
3438-778 Rev A
g336159
1. Block 7.3 cm (2.87 inch)
7.3 cm (2.87 inch)
13. Rotate the blades side-to-side so that they are parallel to the rear of the deck.
14. Loosen the leveling adjustment lock nuts on all 4 corners so that the deck is
sitting squarely on the blocks.
15. Remove any slack from the deck hangers and make sure the deck lift foot
lever is pushed back against the stop.
16. Tighten the 4 leveling adjustment lock nuts.
17. Verify that the blocks fit snugly under the deck skirt and that all attachment
bolts are tight.
18. Continue leveling the deck by checking the front to rear blade slope.
19. Recheck the level of the blades and repeat deck leveling procedure if
necessary.
20. For 60 inch decks only:
• Raise the deck to the transport position.
• Install the lift assist spring adjusting screw (removed in step 7 above).
• Set the gap between the spring and the bracket to 22–29 mm (7/8 - 1-1/8
inches).
21. Connect the battery by installing the positive cable first, then the negative
cable to the battery.
Figure 68
2. Welds
Block Height
Page 6–11
Rake
4.8 - 6.4 mm (3/16 - 1/4 inch)
Deck: Service and Repairs