Toro Z MASTER 2000 Series Service Manual page 74

MYRIDE® Installation (continued)
Chassis: Service and Repairs
g336047
6. Lower the seat and sub-frame all the way onto the machine.
7. Disconnect the seat and sub-frame from the overhead lift.
8. Secure the front shock with a shoulder bolt.
Note: Thread should be on the LH side of the machine (from operator's
position).
g336051
9. Disconnect the seat and sub-frame from the overhead lift.
10. Install the 2 nuts securing the lower shock mounts to the ROPS tubes.
Torque to 122 N • m (90 ± 9 ft-lb).
11. Raise the ROPS back into operating position.
Figure 59
Figure 60
Page 5–34 2000 Series Z MASTER® Service Manual
3438-778 Rev A