Right Console Replacement - Toro Z MASTER 2000 Series Service Manual

Right Console Replacement

Right Console Removal
2000 Series Z MASTER® Service Manual
3438-778 Rev A
1. Park the machine on a level surface and disengage the PTO. Stop the
engine, wait for all moving parts to stop, and remove the key. Engage the
parking brake.
2. Disconnect the battery by removing the negative cable first, then the positive
cable from the battery.
3. Remove the shoulder bolt (T30) at the front of the console.
g336084
4. Remove the 2 bolts on the front of the console.
5. Remove the 2 (T25) screws from the console bracket on the underside of
the console.
Note: Removing the drive wheel may allow easier access to the torx screws.
6. Remove the 2 bolts from the support bracket.
7. Remove the hex screw securing the control panel assembly to the console.
8. Lift the console upward off of the machine, while feeding the control panel
assembly through the opening in the console.
Note: The control panel assembly should be supported while servicing the
machine, to avoid damage to cables or the wire harness.
Figure 27
Page 5–13 Chassis: Service and Repairs