Toro Z MASTER 2000 Series Service Manual page 73

MYRIDE® Removal (continued)
MYRIDE® Installation
2000 Series Z MASTER® Service Manual
3438-778 Rev A
g336049
8. Remove the 2 shoulder bolts securing the trailing arm to the lower ROPS
tubes.
9. Using an overhead lift, raise the seat up about 30 cm (12 inches).
10. Disconnect the seat switch.
11. Lift the seat and sub-frame assembly up and away from the machine.
1. With the seat and sub-frame assembly attached to the overhead lift, lower
the seat into the machine, leaving room under the seat.
2. Connect the seat switch.
3. Lower the seat and sub-frame assembly to align the trailing arm with the
mount holes in the ROPS tube.
g336050
4. Install the 2 shoulder bolts securing the trailing arm to the lower ROPS tubes.
Torque to 50 N • m (37 ± 3 ft-lb).
5. Route the 2 cables back into the cable retainer and fasten.
Figure 57
Figure 58
Page 5–33 Chassis: Service and Repairs