Toro Z MASTER 2000 Series Service Manual page 98

Hydrostatic Drive Transmission Installation (continued)
Drive System: Service and Repairs
g336199
12. Install the drive belt.
13. Install the mower belt.
14. Verify that the wheel hub nut is properly torqued, torque to 325-353 N • m
(250 ± 10 ft-lb).
15. Install the drive wheel and torque the lug nuts, torque to 122-135 N • m (95 ±
5 ft-lb).
16. Add hydraulic oil to the reservoir to the FULL COLD line.
17. Connect the battery terminals and verify proper function.
18. Follow the purging procedure to remove all air from the system.
Procedure (page 7–7)
Note: Check level of the hydraulic fluid and add if necessary.
19. Adjust the neutral setting if necessary.
20. Lower the unit.
21. Adjust the tracking if necessary.
22. Connect the battery by installing the positive cable first, then the negative
cable to the battery.
Figure 78
Hydrostatic Drive Belt Replacement (page 7–8)
Mower Belt Replacement (page 6–6)
Tracking Adjustment (page 7–7)
Page 7–12
Purging
2000 Series Z MASTER® Service Manual
3438-778 Rev A