Motion Control Assembly Removal (continued)
Motion Control Assembly Installation
2000 Series Z MASTER® Service Manual
3438-778 Rev A
g337843
7. Disconnect the motion control assembly from the frame.
g336044
8. Lower the motion control assembly through the frame toward the center of
the machine, remove the assembly.
1. Position the motion control assembly in place with the linkage extending
toward the transmission.
2. Secure the motion control assembly to the frame.
3. Connect the motion control linkage to the transmission.
4. Adjust the nut on the motion control assembly until the motion control nut is
centered in the control plate slots.
Figure 51
Figure 52
Page 5–29
Chassis: Service and Repairs