Toro Z MASTER 2000 Series Service Manual page 96

Hydrostatic Drive Transmission Removal (continued)
Hydrostatic Drive Transmission Installation
Drive System: Service and Repairs
g336197
13. Disconnect the hydraulic fluid hose from the top of the transmission.
14. Remove the bolt that connects the transmission to the cross shaft.
15. Remove the 2 front and rear hydro mounting bolts.
g336195
1. Front and Rear Mounting Bolts
2. Cross Shaft
16. Support the transmission, loosen and remove the two axle horn nuts and
bolts. Lower the transmission.
1. Lift and support the transmission, and install the 2 axle horn bolts, washers,
and nuts. Do not fully tighten the nuts at this time.
2. Align the cross shaft and install the bolt through the transmission into the
cross shaft. Do not tighten at this time.
Figure 75
Figure 76
3. Axle Horn Bolts
Page 7–10 2000 Series Z MASTER® Service Manual
3438-778 Rev A