Kawasaki Engine Replacement - Toro Z MASTER 2000 Series Service Manual

Toro Twin Cylinder Engine Installation (continued)

Kawasaki Engine Replacement

Kawasaki Engine Removal
2000 Series Z MASTER® Service Manual
3438-778 Rev A
g335893
19. Connect the fuel supply line to the fuel filter.
20. Install the engine guard.
21. Open the fuel supply valve.
22. Fill the crankcase with approved oil and verify proper oil level.
23. Connect the battery by installing the positive cable first, then the negative
cable to the battery.
24. Verify proper function of the unit.
Note: Verify engine speed is set to 3600 ± 50 RPM (or 3000 ± 50 RPM
for TE models).
1. Park the machine on a level surface and disengage the PTO. Stop the
engine, wait for all moving parts to stop and remove the key. Engage the
parking brake.
2. Disconnect the battery by removing the negative cable first, then the positive
cable from the battery.
3. Close the fuel supply valve.
4. Remove the engine guard.
5. Remove the mower belt.
6. Remove the hydrostatic drive belt from the engine pulley.
Belt Replacement (page 7–8)
7. Disconnect the chassis wire harness from the main engine wire harness.
Figure 12
Mower Belt Replacement (page 6–6)
Page 4–9
Hydrostatic Drive
Engine: Service and Repairs