HP A6604 Installation Manual page 79

Figure 4-37 Connect the AUX cable
(1) AUX port
(3) AUX cable
(5) DB-25 (male) or DB-
Connecting the Management Ethernet Interface Connecting the Management Ethernet Interface
The management Ethernet interface is an auto
45 interface. It helps you to upgrade software and manage the router through a network 45 interface. It helps you to upgrade software and manage the router through a network 45 interface. It helps you to upgrade software and manage the router through a network
management server. It is not a service interface, and therefore, it cannot send or receive data. management server. It is not a service interface, and therefore, it cannot send or receive data. management server. It is not a service interface, and therefore, it cannot send or receive data.
You can connect the management Ethernet interface to the configuration terminal with a onnect the management Ethernet interface to the configuration terminal with a onnect the management Ethernet interface to the configuration terminal with a
straight-through cable or crossover cable. through cable or crossover cable.
Follow these steps to connect the management Ethernet interface to the configuration terminal: Follow these steps to connect the management Ethernet interface to the configuration terminal: Follow these steps to connect the management Ethernet interface to the configuration terminal:
Step1 Turn off the power switches Turn off the power switches on all power modules of the router. Connect the RJ
of the console cable to the console port on the router and the DB of the console cable to the console port on the router and the DB-9 (female) connector to the
serial interface on the configuration terminal. serial interface on the configuration terminal.
Step2 Connect one end of an Ethernet cable to the management Ethernet interface on the router, and Connect one end of an Ethernet cable t
the other end to the Ethernet interface on the configuration terminal. the other end to the Ethernet interface on the configuration terminal.
A management Ethernet cable is connected in the same way for both the A management Ethernet cable is connected in the same way for both the A6608
The following figure uses the
Connect the AUX cable
-9 (male) connector
interface is an auto-sensing 10Base-T/100Base-TX/1000Base
on all power modules of the router. Connect the RJ-45 connector
o the management Ethernet interface on the router, and
A6608 as an example.
(2) RJ-45 connector
(4) Modem
TX/1000Base-T RJ-
9 (female) connector to the
A6608 and the A6604.