HP A6604 Installation Manual page 63

Figure 4-11 Install a chassis accessory
Step4 Gently push the chassis accessory (with the components facing left) into Slot 1 along the slide
rails until the positioning pins on the backplane are seated in the positioning holes at the bottom
of the chassis accessory. Then push the ejector levers inward to lock the chassis accessory in
position and fasten the captive screws on the ejector levers.
Step5 Gently push the RPE-X1 into Slot 1 along the slide rails, and then push the ejector levers
inward to lock the board in position.
Figure 4-12 Insert the RPE-X1 into the slot
Step6 Fasten the captive screws clockwise with a Philips screwdriver.
Figure 4-13 Fasten the captive screws on the RPE-X1