HP A6604 Installation Manual page 76

#Apr 26 15:35:28:493 2008 HP DEV/1/SUB CARD INSERTED:
Trap 1.3.6.1.4.1.2011.2.23.1.12.1.13<hwSubcardInsert>: frameIndex is 0, slotIndex
0.5, subslotIndex 0.5.1
%Apr 26 15:35:28:493 2008 HP DEV/4/SUBCARD INSERTED:
SubCard is inserted in Frame 0 Slot 2 SubSlot 4, type is MIM-2GBE.
%Apr 26 15:35:29:162 2008 HP DRVICOUT/1/DrvIcOutStr:Slot=5;(Src Slot[5])
Slot 5/1 Plug In Successfully!
Press Enter. The following message appears on the terminal screen:
System is busy with VIU configuration recovery, please wait a moment...
<HP>
This means the MIM has been successfully installed.
2) If the router does not recognize the MIM or the MIM installation failed, the following information
appears on the terminal screen:
<HP>
%Apr 26 15:36:09:404 2008 HP DRVICOUT/1/DrvIcOutStr:Slot=2;(Src Slot[2])
Slot 2/4 Plug In Failed!
<HP>
The device supports hot-swapping of MIMs.

When installing a MIM, use proper force and keep the MIM in the horizontal position to avoid

damage to components on the card.
Removing a MIM
Be sure to run the remove slot slot-number subslot subslot-number command before

removing a MIM while the router is operating.
If you have run this command but do not want to remove the MIM, you can use the undo

remove slot command to cancel the operation.
It is unnecessary to execute the undo remove slot command after you remove a MIM and

insert it again.
Follow these steps to remove a MIM:
Step1 Face the front panel of the router.
Step2 Locate the MIM to be removed.
Step3 Remove the fastening screws on the MIM counterclockwise with a flat-blade screwdriver.