HP A6604 Installation Manual page 24

Technical specifications
Table 1-17 Technical specifications for FIP-100
Processor
Processor cores
Flash
Memory type and size
NVRAM
Combo interfaces
HIM
MIM
Dimensions (H × W × D)
Hardware encryption
Power consumption
hot-swapping
For a Combo interface, the default operating interface is the electrical interface.

For a Combo interface, you can use either the electrical Ethernet interface or the optical

Ethernet interface. You can use the combo enable { copper | fiber } command in interface
view to switch between the optical and electrical interfaces.
For details about the combo enable { copper | fiber } command, refer to Ethernet Interfaces in

the Access Volume of HP SR6600 Routers User Manual.
Use optical transceivers provided by HP only. The device may be incompatible with other

optical transceivers and thus displays alarms automatically.
"Hot-swapping" a module refers to first using the remove slot slot-number command to stop

the module, and then manually pulling it out, or inserting the module into its slot without
powering off the device. For details about the remove slot command, refer to Device
Management in the System Volume of HP SR6600 Routers User Manual.
Item
Power PC 1GHz
1
4 MB
DDR2 SDRAM
1 GB (default, one 1 GB memory module)
2 GB (maximum)
128 KB
2
electrical interfaces
(automatic MDI/MDI-X)
optical interfaces
Not supported
Four MIMs supported at the same time
45 × 399 × 412 mm (1.77 × 15.71 × 16.22 in.)
Supported
50 W
Supported
Specification
10 Mbps, half/full-duplex
100 Mbps, half/full-duplex
1000 Mbps, full-duplex
1000 Mbps, full-duplex