HP A6604 Installation Manual page 33

Technical specifications
Table 1-26 Technical specifications for the FIP-210
Processor
Processor cores
Flash
Memory type and size
NVRAM
Combo interfaces
HIMs
MIMs
Dimensions (H × W × D)
Hardware encryption
Power consumption
Hot-swapping
For a Combo interface, the default operating interface is the electrical interface.

For a Combo interface, you can use either the electrical Ethernet interface or the optical

Ethernet interface. You can use the combo enable { copper | fiber } command in interface
view to switch between the optical and electrical interfaces. For details about the combo
enable { copper | fiber } command, refer to Ethernet Interfaces in the Access Volume of HP
SR6600 Routers User Manual.
Use optical transceivers provided by HP only. The device may be incompatible with other

optical transceivers and thus displays alarms automatically.
"Hot-swapping" a module refers to first using the remove slot slot-number command to stop

the module, and then manually pulling it out, or inserting the module into its slot without
powering off the device. For details about the remove slot command, refer to Device
Management in the System Volume of HP SR6600 Routers User Manual.
Item
MIPS 1GHz
8
4 MB
DDR2 SDRAM
2 GB (default, two 1 GB memory modules)
2 GB (maximum)
128 KB
2
2 electrical interfaces
(automatic MDI/MDI-X)
2 optical interfaces
2
2
45 × 399 × 412 mm (1.77 × 15.71 × 16.22 in.)
Supported
125 W
Supported
Specifications
10 Mbps, half/full-duplex
100 Mbps, half/full-duplex
1000 Mbps, full-duplex
1000 Mbps, full-duplex