Figure 4-9 Interior structure of the RSE
(1) Positioning holes
(3) CPU heatsink
(5) Bridge heatsink 2
(7) Memory module
Installing an RPE-X1
Step1
Face the front panel of the router.
Face the front panel of the router.
Step2
Locate the slot where you will install the RPE
Locate the slot where you will install the RPE-X1 (Slot 0 or Slot 1, the figures below illustrate
how to install an RPE-X1 to Slot 1).
Step3
Install a chassis accessory to hold the RPE
Figure 4-10 Structure of the chassis accessory
(1) Positioning holes
(3) Power connector
Interior structure of the RSE-X1
X1 to Slot 1).
to hold the RPE-X1.
Structure of the chassis accessory
(2) Bridge heatsink 1
(4) Bus connectors
(6) Power connector
(8) Release latch
X1 (Slot 0 or Slot 1, the figures below illustrate
(2) Bus connectors
(4) Slide rail