HP A6604 Installation Manual page 70

Figure 4-24 Insert a FIP
Step4 Fasten the captive screws on the FIP clockwise with a Philips screwdriver.
Figure 4-25 Fasten the captive screws
Step5 Turn on the power switch of the router if the router is powered off.
Step6 After the FIP is powered on, the RUN LED (green) flashes once and then flashes fast (at 8 Hz).
It flashes slowly (at 1 Hz) after the application is loaded. This means that the FIP runs normally.
The device supports hot-swapping of FIPs.

If there is a great resistance when you push a FIP into a slot, first remove the blank panels at

both sides of the slot, then install the FIP, and finally install the removed blank panels to prevent
dust from entering the chassis.
Do not insert or remove a HIM/MIM into or from a FIP when the RUN LED on the FIP is blinking

fast. Otherwise, an exception may occur.
By default, the RUN LEDs of the FIPs will light up in the ascending order of slot numbers.

For a device configured with an RPE-X1 and a combination of FIPs including FIP-100, FIP-110,

FIP-200, and FIP-210, the application of FIP-110/FIP-200/FIP-210 is loaded faster than the
application of FIP-100, that is, the RUN LEDs of the FIP-110/FIP-200/FIP-210 start to blink long
before the RUN LED of the FIP-100 does. Do not remove the FIP-100 at this moment.
For more information of the FIP LEDs, see "FIPs" in Chapter 1 "Router Overview."
