HP A6604 Installation Manual page 36

Figure 1-29 Combo interfaces on a FIP-100
(1) 1000 Mbps optical Ethernet interface (SFP1)
(2) 10/100/1000 Mbps electrical Ethernet interface (GE0) LED
(3) 10/100/1000 Mbps electrical Ethernet interface (GE1)
(4) 10/100/1000 Mbps electrical Ethernet interface (GE1) LED
(5) 10/100/1000 Mbps electrical Ethernet interface (GE0)
(6) 1000 Mbps optical Ethernet interface (SFP0)
(7) 1000 Mbps optical Ethernet interface (SFP0) LED
(8) 1000 Mbps optical Ethernet interface (SFP1) LED
For a Combo interface, you can use either the electrical Ethernet interface or the optical
Ethernet interface. You can use the combo enable { copper | fiber } command in interface
view to switch between the optical and electrical Ethernet interfaces. For details about the
combo enable { copper | fiber } command, refer to Ethernet Interfaces in the Access Volume
of HP SR6600 Routers User Manual.
Technical specifications for Combo interfaces
Technical specifications for electrical Ethernet interfaces

Table 1-30 Technical specifications for electrical Ethernet interfaces
Connector
Interface type
Frame format
Rate and duplex mode
Interface cable and maximum transmission distance
Item
(9) Run LED (RUN)
Specification
RJ-45
Automatic MDI/MDI-X
Ethernet_II
Ethernet_SNAP
10 Mbps, half/full-duplex
100 Mbps, half/full-duplex
1000 Mbps, full-duplex
Twisted pair with a maximum transmission distance
of 100 m (328.08 ft.)