HP A6604 Installation Manual page 25

LEDs
Figure 1-18 FIP-100 LEDs
(1) LED for 10/100/1000 Mbps electrical Ethernet interface 0
(2) LED for 10/100/1000 Mbps electrical Ethernet interface 1
(3) 1000 Mbps optical Ethernet interface LED (SFP0)
(4) 1000 Mbps optical Ethernet interface LED (SFP1)
(5) Run LED (RUN)
Table 1-18 Description of FIP-100 LEDs
LED
RUN (green)
SFP0 to SFP1
(yellow/green)
GE0 to GE1
(yellow/green)
Slots
An FIP-100 can be inserted in slot 2 or 3 of the A6604 and slot 2, 3, 4, or 5 of the A6608. FIP-
100 provides four MIM slots for some HP legacy MIMs. The MIM slots on FIP-100 are
numbered 1 to 4 from the bottom up and from right to left, as shown in
Status
Off No power input is available or the FIP-100 has failed.
Slow blinking (1 Hz) The FIP100 is working normally.
Application software is being loaded (in this case, never power
Fast blinking (8 Hz) off the device or hot-swap the FIP100; otherwise the FIP100
may be damaged) or FIP-100 is not working.
Off No optical link is present.
Solid green An optical link is present.
Blinking green Data is being sent or received at a rate of 1000 Mbps.
Solid yellow The optical transceiver failed to be detected.
Off No link is present.
Solid green A 1000 Mbps link is present.
Blinking green Data is being received or transmitted at a rate of 1000 Mbps.
Solid yellow A 10/100 Mbps link is present.
Blinking yellow Data is being received or transmitted at a rate of 10/100 Mbps.
Meaning
Figure 1-19.