HP A6604 Installation Manual page 73

Figure 4-29 Fasten the captive screws
Step6 Power on the router if the router is off.
1) After the HIM is initialized, the following information will be displayed on the configuration
terminal screen:
#Apr 26 15:35:28:493 2008 HP DEV/1/SUB CARD INSERTED:
Trap 1.3.6.1.4.1.2011.2.23.1.12.1.13<hwSubcardInsert>: frameIndex is 0, slotIndex
0.5, subslotIndex 0.5.1
%Apr 26 15:35:28:493 2008 HP DEV/4/SUBCARD INSERTED:
SubCard is inserted in Frame 0 Slot 2 SubSlot 2, type is HIM-8GBE.
%Apr 26 15:35:29:162 2008 HP DRVICOUT/1/DrvIcOutStr:Slot=5;(Src Slot[5])
Slot 5/1 Plug In Successfully!
Press Enter. The following message appears on the terminal screen:
System is busy with VIU configuration recovery, please wait a moment...
<HP>
This means the HIM has been successfully installed.
2) If the router does not recognize the HIM or if the HIM installation failed, the following
information appears on the terminal screen:
<HP>
%Apr 26 15:36:09:404 2008 HP DRVICOUT/1/DrvIcOutStr:Slot=2;(Src Slot[2])
Slot 2/2 Plug In Failed!
<HP>
The device supports hot-swapping of HIMs.

When installing a HIM, use proper force and keep the HIM in the horizontal position to avoid

damage to components on the card.
Make sure that the HIM is inserted in the FIP before you restart the FIP or insert the FIP in the

router; otherwise, the HIM configurations do not take effect.
Removing a HIM